Product category: PLCs – Omron – C – Omron CH-LK (CHLK) This unit is fully tested prior to. Q: Can CH-LKV1 Host Link Unit be used with CS1-series Programmable Controllers?. CH Units that use the CPU bus, SYSMAC LINK Unit, CHW-SLK23/24 ( wired) CHW-SLK13/14 (optical). Controller Link Unit, CHW-CLK21 (wired ).

Author: Gull Kizilkree
Country: Denmark
Language: English (Spanish)
Genre: Marketing
Published (Last): 4 April 2015
Pages: 19
PDF File Size: 4.81 Mb
ePub File Size: 9.50 Mb
ISBN: 398-4-87884-396-4
Downloads: 58227
Price: Free* [*Free Regsitration Required]
Uploader: Golmaran

Omron C500CN221EU Programming Cable, For Use With C200H-LK201 PLC, 6 ft

Help me with ch-lk Started by sokhanh13 Nov li201 Try to put il elsewhere. Posted 21 Nov On the CPU, led “run” is green. Edited 16 Nov by sokhanh.

Create an account or sign in to comment You need to be a member in order to leave a comment Create an account Sign up for a new account in our community. Posted 15 Nov The restriction is strictly mechanical.

I would still think you should see the RCV light. No electrical or logical restriction for using these slots with CH-LK All the configuration is done lk21 the LK switches. Share this post Link to post Share on other sites. The dip witches in the host link are correct but still not connect. You should verify the cable. I will check the cable one more time!

Related Posts (10)  POLIPOS NASALES PDF

Posted 16 Nov edited. Try turning if OFF. Neither of them are V1’s. The long port at the bottom is for a 3G2A6-LK This may or may not be an issue if they are mismatched This is basically the same as the rack mounted unit you have.

Pin 3 on the back may be the problem depending on how your custom application was programmed. Thank you for your reoly! Posted 13 Nov Posted 15 Nov edited. Edited 15 Nov by sokhanh. The manual in the link I posted above describes these functions. Started by sokhanh13 Nov Maybe the PLC power supply is bad. One says not to use those slots, the other says it’s OK but you will lose some functionality on the peripheral port.

I also tried with this cable LK Coputer With the information you have provided, there is no way for us to tell.

Omron SYSMAC C200h-lk201 Host Link Unit C200HLK201

Then the PLC cannot connect to Pc. Posted 14 Nov I have replaced ch-lkv1 by ch-lk and everything is the same. In any case, look here: If this is a 1 to 1 connection between the PC and the PLC then this is probably correct but not guaranteed. This is common Omron serial settings.

Related Posts (10)  ANGELCARE AC401 PDF

Omron CH-LKV1 Industrial Control System | eBay

Prev 1 2 Next Page 1 of 2. You need to be a member in order to leave a comment. On the older ones, it was only intended for the hand held programmer.

Posted 22 Nov Sign up for a new account in our community. After revisiting this I found conflicting information in the manuals.

Omron CCNEU Programming Cable, For Use With CH-LK PLC, 6 ft Buy from Cross

But there’s still no RCV light Please help me! If your application is not sending an c020h and a calculated FCS then it will not communicate with pin 3 set to ON.

This means you cannot use the small peripheral port for anything other than a hand held programmer.