Burst Strength Attachment (ASTM D). Brochure Share. Request Info . Product Details Standards Get a Quote. Product Details. Burst Strength. ASTM D determines the measurement for bursting strength with a ball burst strength tester of textiles or garments that exhibit a high degree of ultimate. Page 1. — — 27 —>. Ø K-. k— ASTM D Fixture.
|Published (Last):||6 December 2008|
|PDF File Size:||5.88 Mb|
|ePub File Size:||1.55 Mb|
|Price:||Free* [*Free Regsitration Required]|
Within the test, the inch-pound units are shown in parentheses.
Other materials with established test values may be used for this purpose. Test Method D is considered satisfactory d37877 acceptance testing of commercial shipments astm d3787 textiles fabrics for bursting strength since the method has been used extensively in the trade for acceptance testing.
Historical Version s – view previous versions of standard. The kind of force transfer and strength that occur when knitted goods are worn is prevented by clamping them as directed in this test method.
Link to Active This link will always route to the d3877 Active version of the standard. This standard does astm d3787 purport to address all of the safety concerns, if any, associated with its use.
For astm d3787 measurement of bursting strength with a hydraulic testing machine, refer to Test Method D Referenced Documents purchase separately The documents listed below astm d3787 referenced within the subject standard but are not provided as part of the standard. The test samples used should be as homogeneous as possible, drawn from the material from which the disparate test results were obtained, and randomly assigned in equal numbers to the laboratories for astm d3787.
The values stated in each system are not exact equivalents; therefore, each system may be used independently of the other. The astm d3787 results from the two laboratories should be compared using a statistical test for unpaired data at a probability level chosen prior to the testing series. Combining values from the two astm d3787 may result in nonconformance within the specification.
ASTM D Textile Ball Burst Testing – ADMET
If a bias is astm d3787, either the cause must be determined and corrected or future test results must be adjusted in consideration of known bias. In astm d3787 of disagreement arising from differences in values reported by the purchaser and the seller astm d3787 using Test Method D for acceptance testing, the statistical bias, if any, between the laboratory of the purchaser and the laboratory of the seller should be determined with comparison based on testing specimens randomly drawn from one sample of material of the type being evaluated.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and astm d3787 the applicability of regulatory limitations prior to use.